ÎÏ 3000

IRRIGATOR MADE OF CORRUGATED PVC SHEET FOR COOLING TOWERS

The irrigators made of corrugated PVC sheets are used in the fan cooling towers and are designed for cooling of technologic circulating water.

The installation of irrigator blocks in the cooling tower is made in one, two or three tiers, depending on the requirements for the cooling effect.

The irrigator block is a set of vacuum-molded corrugated sheets interconnected with connecting elements.

Technical characteristics of irrigators

Type of irrigator ÎÏ-3000
Square of heat transfer, m2/m3 102
Overall dimensions of the block (length • width • height), mm 2440õ320õ610
Weight of the block, kg 12,5
Irrigation density range, m3/ m2·hour 5÷20
Operation temperature range, °C -30 ÷ +65
Height of corrugation, mm 30
Angle of corrugation decline, ° 30

 Irrigator made of corrugated PVC sheets ÎÏ-3000

Fig. 1 Irrigator made of corrugated PVC sheets ÎÏ-3000

The cooled water is sprayed on top of the irrigator blocks and under the influence of gravity flows down as a film on the corrugated surface of the sheets. The intense water cooling is ensured through flowing of water film downwards in the air counter flow. The irrigators made of corrugated sheets provide the largest contact surface for heat exchange of water with air at aerodynamic resistance, which is weaker in comparison with the ones of irrigators of other types, thus the highest cooling effect of water is achieved.

The assembling of irrigator blocks is simple, convenient and takes little time, it is performed at the installation site. Transport costs are minimal (10-12 times less in comparison with the costs of other types of irrigators).

G Analytics
ñàéò ñîçäàí êîìïàíèåé